ATF Lines, Removing And Installing: Notes
WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Used Oil Collection and Extraction Unit:SMN372500
- Hose diameter approximately 18 mm
- Compressed air gun, commercially available
- Protective Eyewear
Removing and Installing
- General repair instructions. Refer to GENERAL REPAIR INFORMATION .
- Guidelines for clean working conditions. Refer to GUIDELINES FOR CLEAN WORKING CONDITIONS .
- Seal the open lines and connections with clean plugs from the :VAS6122 .
- Replace the O-rings after removal.
- Check the ATF level after removing and Installing ATF lines. Refer to ATF LEVEL, CHECKING .
-- Remove the noise insulation. Refer to apporpriate Repair Information .
-- Disconnect the ATF lines -arrows-. Refer to Figure.
-- Remove the bolts -arrows- and remove the ATF lines from the transmission. (different versions)
CAUTION:
Risk of damaging the transmission due to faulty ATF cooling system.
- Remove the plugs on the ATF lines and on the transmission.