Seat Depth Adjuster Cushion, Removing And Installing: Removing

WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the trim from the seat depth adjuster. Refer to SEAT DEPTH ADJUSTER TRIM, REMOVING AND INSTALLING .

-- Disconnect the connector -1-, if equipped.

Courtesy of AUDI OF AMERICA, LLC

-- Release the hooks -arrows- and fold the cushion and cover toward the rear.

-- Disengage the tabs -arrows- from the seat depth adjuster -2- and move the cushion and cover upward.

Courtesy of AUDI OF AMERICA, LLC

-- To do this, remove the seat depth adjuster cushion -1- upward and toward the front.

-- Remove the retaining channel -2- from the retainers -5-.

Fig 1: Identifying Cover -1-, Channels -2-, Seat Depth Adjuster Cushion -3-, Tabs -4- & Catches -5-

Courtesy of AUDI OF AMERICA, LLC

-- Disengage the cover from the retainers -4- on both sides.

-- Remove the seat depth adjuster cushion -3- from the cover -1-.