Seat Bolster Heating Element, Removing And Installing
WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
The old seat heating element remains on the cushion and will be covered by the new heating element.
Procedure
- The seat bolster cushion is removed from the seat pan. Refer to SEAT PAN COVER AND CUSHION, REMOVING AND INSTALLING .
-- Cut the wire directly on the old heating element.
-- Align the new heating element -arrow- on the cushion.
-- Peel the protective film off the heating element. Be careful not to damage the heating element.
-- Glue the heating element so that it aligns with the old heating element and is not wrinkled.
Further installation is performed in reverse order of the removal.