Locking Mechanism Trim, Removing And Installing: Removing
WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Release the folding backrest.
-- Make sure the button -2- (indicator) is in the >>up<< position.
-- Push the tabs -arrows- on both sides of the trim using a Trim Removal Wedge :3409 .
-- Remove the trim -1- upward and off the rear seat backrest -3-.
-- Remove the trim -1- in the front section as far as possible upward from the rear seat backrest.
Fig 2: Using A Flat-Head Screwdriver, Pry Clip -Arrow- Located In The Rear Area Of Trim -1- Out Of Retainer
-- Pry the catch -arrow- in the rear section of the trim out of the locking mechanism using a flat-head screwdriver.
-- Remove the trim upward from the rear seat backrest.