Headrest Guide, Removing And Installing, Center Folding Backrest, 2+1 Divided Seats: Removing
WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the rear headrest. Refer to HEADREST, REMOVING AND INSTALLING .
-- Using a waterproof felt-tip pen, make a marking -2- on the T-Handle Hook : 3438 at a distance of -a- = approximately 80 mm from the point of the hook.
-- Guide the T-Handle Hook :3438 from above into the headrest guide -arrow- as far as the marking and insert into the hole -1- for the tab.
-- Turn the T-Handle Hook :3438 90° -arrow A-.
- The hook must not slide out of the hole.
TIP:
The rotational movement will cause the tab to bend away to the side and is no longer engaged.
-- Pull the headrest guide with the hook out of the backrest -arrow B-.