Seat Angle Adjuster, Removing And Installing: Removing
WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Move the front seat into its highest position.
-- Unscrew the front seat and tip to the rear with the wires attached. Refer to FRONT SEAT, REMOVING AND INSTALLING .
CAUTION:
Risk of damaging the bearing bushing in the adjusting spindle if handled incorrectly.
The bushing cannot be replaced with workshop materials. If the bushing is damaged, the corresponding assembly parts must be replaced.
- Remove and install the threaded connection -1- for the adjusting spindle/seat pan carefully.
-- Remove the bolt -1- for the seat angle adjustment motor adjusting spindle.
-- Disconnect the connector -2- from the seat angle adjustment motor.
-- Remove the bolts -4- and remove the seat angle adjuster motor -3-.