Gear Oil Level, Checking, Front Final Drive, Transmission With Separate Oil System

WARNING: This page is about a different car, the 2024 Audi S6. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Used Oil Collection and Extraction Unit:SMN372500
Pressurized Gearbox Oil Filler Kit:VAS6617
Protective Eyewear
Protective gloves

Procedure

Gear oil temperature: approximately 20 °C (68 °F) (room temperature).
Move the vehicle onto a 4-column workshop hoist or over a work pit so it is completely level.
Transmission is in "P".
The parking brake button is pressed to activate the electro-mechanical parking brake.

General repair instructions. Refer to GENERAL REPAIR INFORMATION .
Guidelines for clean working conditions. Refer to GUIDELINES FOR CLEAN WORKING CONDITIONS .
Always maintain the specified transmission fluid level. The transmission is very sensitive to overfilling.
Replace the plug for the inspection and fill hole.

-- Remove the noise insulation. Refer to OVERVIEW - NOISE INSULATION .

-- Remove the right drive axle cover. Refer to OVERVIEW - FRONT WHEEL HOUSING LINER .

-- Place the :SMN372500 under the transmission.

Fig 1: Identifying Drain Plug From Front Final Drive

Courtesy of AUDI OF AMERICA, LLC

-- To catch escaping gear oil, place multiple cloths on the subframe crossbrace.

CAUTION:

Risk of injury due to fluid escaping.

Irritation and injury to the skin and eyes are possible.

- Wear protective eyewear.

- Wear safety gloves.

-- Remove the drain plug -arrow A- from the front final drive.

Specified value: The oil level is correct when the front final drive is filled to the lower edge of the filler opening.

-- Let any excess oil drain.

If the Oil Level in the Front Final Drive Is Not at the Lower Edge of the Oil Filler Hole:

Fig 2: Installing Adapter VAS 6617/6 & Adapter VAS 6617/2 Into Transmission Hand-Tight

Courtesy of AUDI OF AMERICA, LLC

-- Install the :VAS6617/6 with the :VAS6617/2 in the inspection and fill hole in the front final drive.

-- Connect the :VAS6617 and fill the front final drive with gear oil.

Transmission fluid. Refer to the Parts Information.

-- Remove the :VAS6617/6 from the transmission and let any extra gear oil drain out.

-- Tighten the new drain plug -arrow A- for the front final drive.

Fig 3: Identifying Drain Plug From Front Final Drive

Courtesy of AUDI OF AMERICA, LLC

-- Remove the cloth from the subframe crossbrace.

Tightening Specifications

Refer to Drain and Plug
Refer to OVERVIEW - NOISE INSULATION .
Refer to OVERVIEW - FRONT WHEEL HOUSING LINER .