Right Flange Shaft, Removing And Installing: Removing
WARNING: This page is about a different car, the 2024 Audi S6. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the right subframe shield. Refer to appropriate service information .
-- Remove the right drive axle heat shield. Refer to appropriate service information .
-- Remove the right drive axle from the transmission and lay toward the rear. Refer to appropriate service information .
-- Place the :SMN372500 under the transmission.
-- Version with M12 threads: install the :VW771 with : VW771/43 on the flange shaft.
-- Versions with M14 threads: place the :VW771 with :VW771/43 and Spindle :VW771/45 on the flange shaft.
-- Remove flange shaft.