Side Window, Installing

WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Pay attention to the repair information. Refer to REPAIR INFORMATION .
Required Tools and Materials for Removal and Installation. Refer to REQUIRED TOOLS AND MATERIALS FOR REMOVAL AND INSTALLATION .

Procedure

-- Prepare the body flange for installation. Refer to BODY FLANGE, PREPARING FOR INSTALLATION .

-- Prepare undamaged window for installation. Refer to UNDAMAGED WINDOW GLASS, PREPARING FOR INSTALLATION , or prepare new window for installation. Refer to NEW WINDOW GLASS, PREPARING FOR INSTALLATION .

Use One-Part Window Adhesive for Side Windows:D 169 300 M1 . If more than one window glass must be installed, the Two-Part Window Adhesive Kit:D 004 660 M2 can also be used.

-- Apply adhesive all around the molding.

-- Apply adhesive to remaining bead on an undamaged cut-out window.

-- Insert the new window glass into the opening for the window, press it onto the C-pillar first with the locating pins and then onto the D-pillar with the locating pin.

-- For a window without a locating pin, align the window lengthwise to the edge on the side panel and then insert it into the opening for the window.

-- Secure the window in window opening with adhesive tape.

Observe minimum curing times. Refer to MINIMUM CURING TIMES FOR BONDED WINDOWS .

Further installation is performed in reverse order of the removal.