Starter, Removing And Installing: Removing

WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Disconnect the battery. Refer to the appropriate service information .

-- Remove the emissions control module. Refer to the appropriate service information .

-- Loosen the rear coolant pipes on the transmission and push to the side. Refer to the appropriate service information .

-- Remove the bolt -arrow-.

Fig 1: Identifying Plenum

Courtesy of AUDI OF AMERICA, LLC

-- Remove the starter generator. Refer to the appropriate service information .

-- Remove the right engine support. Refer to the appropriate service information .

-- Remove the bolt -5-.

Fig 2: Identifying Starter Overview

Courtesy of AUDI OF AMERICA, LLC

-- Remove the nut -4-.

-- Remove the Starter -B- -1-.

-- Disconnect the connector -3-.

-- Free up the B+ wire -2-.