Starter, Removing And Installing: Removing

WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Disconnect the battery. Refer to STARTER, REMOVING AND INSTALLING, VEHICLES WITH 2.0L TFSI ENGINE BATTERY A, DISCONNECTING AND CONNECTING, VEHICLES WITHOUT ALTERNATIVE DRIVE SYSTEM, (0K0) , or BATTERY A, DISCONNECTING AND CONNECTING, VEHICLES WITH HIGH-VOLTAGE SYSTEM, (0K3) , or BATTERY A, DISCONNECTING AND CONNECTING, VEHICLES WITH ALTERNATIVE DRIVE SYSTEM, (0K4)BATTERY A, DISCONNECTING AND CONNECTING, VEHICLES WITH ALTERNATIVE DRIVE SYSTEM, (0K4) .

-- Remove the bolt -arrow-.

Fig 1: Identifying Plenum

Courtesy of AUDI OF AMERICA, LLC

-- Remove the right engine support. Refer to ENGINE SUPPORT, REMOVING AND INSTALLING .

-- Remove the bolt -5-.

Fig 2: Identifying Starter Overview

Courtesy of AUDI OF AMERICA, LLC

-- Remove the nut -4-.

-- Disconnect the connector -3-.

-- Free up the B+ wire -2-.

-- Remove the Starter -B- -1-.