Starter, Removing And Installing: Installing
WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
-- Check the sealing piece -arrow- for the correct installation position.
Tip
If the starter assembly is difficult to move, use a silicone-free lubricating spray.
CAUTION:
There is a risk of damaging the starter through improper handling.
- Tighten the bolt only with the spacer sleeve installed between the starter and the transmission.
-- Connect the battery. Refer to the appropriate service information .