Battery A, Removing And Installing, Vehicles Without 48V System, (VH0): Installing

WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal while noting the following:

Conditions

At vehicles using a central venting system hose, this hose needs to be inserted in the respective vent opening at the battery again. The vent opening on the opposing side must be cosed with a blind plug.

-- Insert the battery so that the terminal clamp is still accessible.

-- Attach the central venting system hose.

-- When the ignition and electrical equipment are switched off, connect the battery in the following sequence:

-- Insert the main fuse panel -2- onto the battery positive terminal "+".

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the nut -3-.

-- Close the cover -1-.

-- Push the battery all the way to the retaining bracket -1- -arrow-.

Courtesy of AUDI OF AMERICA, LLC

Conditions

Battery clamping strip must engage in the retaining bracket.
The battery must not be able to move at all anymore.

-- Connect the battery. Refer to BATTERY A, DISCONNECTING AND CONNECTING, VEHICLES WITH ALTERNATIVE DRIVE SYSTEM, (0K4) .

If the battery was replaced, then perform the battery adaptation test plan.

-- Perform the "-A- 12 V Battery, Adjusting" function using the Vehicle Diagnostic Tester. Refer to Diagnostic Entries .

Continuation