Clean Working Conditions
WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Even minor contamination can lead to malfunctions and leakage. That is why the following guidelines for clean working conditions must be ensured with all procedures:
- Thoroughly clean the connection locations/maintenance openings and the area around them prior to loosening/opening.
- Use lint-free cleaning cloth for cleaning.
- Seal off cables, connections and components immediately after opening them, using seals from the Engine Bung Set:VAS 6122 .
- Place removed components on a clean surface and cover them with lint-free cleaning cloths.
- Cover or seal opened components carefully.
- Immediately remove leaking liquids and clean the affected areas.
- Only install clean components, remove any replacement parts from their packaging just before installing them and wear clean gloves.
- Supplied transport and protective packaging and sealing cover should only be removed immediately before installing.
- Protect the disconnected electrical or optical connectors from dirt and moisture and only connect when they are dry.
Vehicle and Engine Wash:
- During any cleaning procedures on the vehicle or engine, the water jet of the pressure washer must never be directed onto electric/electronic components or connectors.