LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2024 >> S3 Premium Plus >> Repair and Diagnosis >> External Pages >> Different car >> Section 302 (Gears, Shafts (Servicing - 7-Speed Dual Clutch Transmission 0CJ, 0CL, 0CK, 0DK, 0DN, 0DP, 0HL)) >> 35 Gears, Shafts >> Parking Lock >> Parking Lock, Removing And Installing >> Notes

Parking Lock, Removing And Installing: Notes

WARNING: This page is about a different car, the 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required 

Removing

Parking lock 2, removing

Fig 2: Parking Lock -2-, Removing
GWWA35-10635Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -1-.

-- In the sleeve -1- of the parking lock -2- cut through the M10 threads.

GWWA35-10636Courtesy of AUDI OF AMERICA, LLC

-- Install the Slide Hammer Set:VW771  -1- in the threads of the sleeve -3-.

GWWA35-10630Courtesy of AUDI OF AMERICA, LLC

-- Drive out both sleeves -3- together with the parking lock -2-.

Parking lock 3, installing

Fig 3: Parking Lock -3-, Installing
GWWA35-10648Courtesy of AUDI OF AMERICA, LLC

-- Drive the parking lock -3- in the clutch housing. At the same time drive in the sleeves -2- alternating from side to side using the Valve Guide/Clutch Release Push Rod Seal Drift:10-206  -1- to the dimension -a-.

Dimension -a- = approximately 1.8 mm

Drive in the center sleeve -arrow- flush with the parking lock -3-.

-- Tighten the bolts -1- for the parking lock -2-.

Fig 4: Parking Lock -2-, Removing
GWWA35-10635Courtesy of AUDI OF AMERICA, LLC
Fig 5: Slide off the Output Gear -1- of the Drive Wheel from the Pinion.
GWWA34-11698Courtesy of AUDI OF AMERICA, LLC
Fig 6: Detach the Parking Lock Gear
GWWA34-11703Courtesy of AUDI OF AMERICA, LLC