Input Shaft 1, Disassembling And Assembling: Notes

Courtesy of AUDI OF AMERICA, LLC

Special tools and workshop equipment required 

• Drive Sleeve:30-20 
• Press Piece - Trailing Arm:2010 
• Press Piece - Front Control Arm:2040 
• Press Plate:VW401 
• Press Plate:VW402 
• Press Piece - Multiple Use:VW412 

Special tools and workshop equipment required 

• Thrust Piece:T10431/1 
  Fig 1: Identifying Assembly Tool T10431

  Courtesy of AUDI OF AMERICA, LLC
• Wishbone Rubber Mount Assembly Tool:T10219/1 

  Courtesy of AUDI OF AMERICA, LLC

• Press Tool:T40323 
• Extracting Tool - Press In Piece:T40413/11 

  Courtesy of AUDI OF AMERICA, LLC

• Input shaft 1, removed. Refer to INPUT SHAFT 1, REMOVING AND INSTALLING INDIVIDUALLY .

Disassembling

If necessary, remove the sensor wheel:

Press off the sensor wheel 2

Fig 2: Press off the sensor wheel -1-

Courtesy of AUDI OF AMERICA, LLC

-- Insert the input shaft -1- with the sensor wheel -2- in the corresponding groove of the Press Plate:VW402  -3-.

-- Press off the input shaft -1- downward.

Input shaft 1, pressing out

Fig 3: Input shaft 1, pressing out

Courtesy of AUDI OF AMERICA, LLC

2 -

Thrust Piece:T10431/1 

3 -

Press Tool - Thrust Piece:T40323/5 

4 -

Press Plate:VW 402 

• If not removed, make sure that the sensor wheel -1- is not damaged.