Input Shaft 1, Removing And Installing Individually: Installing
WARNING: This page is about a different car, the 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Carefully guide the input shaft 1 into the gear set -arrow-. While doing so, make sure the needle bearings -A and B- are installed correctly.
-- Position the shift forks and secure with the bolt -arrow-.
AWD Vehicles
-- Warm the bearing inner race using the Inductive Heater:VAS 6414 to approximately 100 °C (212 °F) and push in all the way downward with the shoulder -arrow A-.
-- Install the circlip -arrow-.
-- Install the gear set. Refer to TRANSMISSION, DISASSEMBLING AND ASSEMBLING .