Overview - Bearing Bracket
WARNING: This page is about a different car, the 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Circlip
- Shaft
- For reverse gear intermediate sprocket
- Thrust Washer
- For reverse gear intermediate sprocket
- Reverse Gear Intermediate Sprocket
- Needle Bearing
- For reverse gear intermediate sprocket
- Bolts
- Replace after removing
- 8 Nm +90°
- Retaining Plate
- For input shaft ball bearing
- Input Shaft Ball Bearing
- Bearing "C"
- Installation position. Refer to Assembling
- Removing. Refer to Figure.
- Inserting Assembling
- Locking Sleeves
- Quantity: 4
- Locking sleeves, removing and installing. Refer to Figure.
- Gearshift Rail/Shift Fork for 2nd Gear and Reverse Gear
- Gearshift Rail/Shift Fork for 4th and 6th Gear
- Mounting Bracket
- For Gearshift Rail/Shift Fork for 4th and 6th Gear and Gearshift Rail/Shift Fork for 5th and 7th Gear
- Bolt
- 6 Nm +30°
- Gearshift Rail/Shift Fork for 5th and 7th Gear
- Gearshift Rail/Shift Fork for 1st and 3rd Gear
- Circlip
- Output Shaft Ball Bearing
- Bearing "G"
- Installation position. Refer to Assembling
- Removing. Refer to Figure.
- Inserting Assembling
- Bearing Bracket
- Disassembling and Assembling. Refer to BEARING BRACKET, DISASSEMBLING AND ASSEMBLING .