Charge Air Pressure Sensor -G31-, REMOVING AND INSTALLING, 2.9L ENGINE: Removing

WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Detach the Engine Control Module -J623- with the bracket and push it slightly to the side. Refer to Engine Control Module -J623-, REMOVING AND INSTALLING .

Courtesy of AUDI OF AMERICA, LLC

-- Loosen the hose clamps -1 and 3- and remove the air duct hose.

-- Disconnect the connector -1-.

Fig 1: Charge Air Pressure Sensor -G31- Component Location, 2.9L Engine

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolt -2- and the Charge Air Pressure Sensor -G31-.