Sealing Flange, Removing And Installing, Belt Pulley Side: Removing
WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the vibration damper. Refer to VIBRATION DAMPER, REMOVING AND INSTALLING .
-- Remove the upper air duct pipe. Refer to AIR DUCT PIPE, REMOVING AND INSTALLING .
-- Disconnect the connector -3- and remove the Cylinder Head Coolant Valve -N489- from the bracket -2-.
-- Disconnect the connector -1-.
-- Remove the bolts -arrows- and tie up the bracket to the side.
All additional procedures are described under: SEALING FLANGE, REMOVING AND INSTALLING, BELT PULLEY SIDE .