After-Run Coolant Pump -V51-, REMOVING AND INSTALLING: Installing

WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal while noting the following:

Secure all hose connections with hose clamps that match the ones used in series production. Refer to the Parts Information.
Used coolant cannot be used again.

-- If removed, install the Oxygen Sensor 1 After Catalytic Converter -GX7-. Refer to HEATED OXYGEN SENSOR, REMOVING AND INSTALLING .

-- Install the heat shield and engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .

-- Fill the coolant. Refer to Coolant, Filling .