Right Coolant Pipe On SUBFRAME, Removing And Installing: Removing
WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the noise insulation. Refer to OVERVIEW - NOISE INSULATION .
-- Remove the right drive axle cover and right front wheel spoiler. Refer to OVERVIEW - FRONT WHEEL HOUSING LINER .
-- Loosen the right front wheel housing liner in the front area and push toward the side. Refer to OVERVIEW - FRONT WHEEL HOUSING LINER .
-- Place a cloth underneath to catch any escaping coolant.
-- Clamp off the coolant hoses with the Hose Clamps - Up To 25mm:3094 and then remove.- To remove, loosen the hose clamps -1 and 5-.
-- Free up the wiring duct -4- on the right coolant pipe and on the subframe.
-- Remove the nut -2- and the bolt -3-.
-- Lower the subframe. Refer to appropriate Service Information .
-- Remove the right coolant pipe.