Left Coolant Pipe On SUBFRAME, Removing And Installing: Installing

WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal while noting the following:

Replace the seal and O-ring after removal.
Secure all hose connections with hose clamps that match the ones used in series production. Refer to the Parts Information.
Used coolant cannot be used again.

-- If removed, install the subframe. Refer to appropriate Service Information .

-- If removed, install the left engine mount. Refer to LEFT ENGINE MOUNT, REMOVING AND INSTALLING, 3.0L ENGINE .

-- Connect the coolant hose to the connector coupling. Refer to Figure.

-- Fill the coolant. Refer to Coolant, Filling .