Right A-Pillar Connector Station, Removing And Installing: Removing
WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the A-pillar lower trim panel. Refer to A-PILLAR LOWER TRIM PANEL, REMOVING AND INSTALLING .
-- Push the carpet in the connector station area as far as possible to the side.
-- Disconnect the connector -1-.
-- Disconnect and free up the wire -3- and the antenna wires -4- and -5-.
-- Pry out the connector station -2- from the body.
-- Open the clip -3- -arrow-.
-- Push out the connector terminal -2- from the bracket -1-.