Vehicle Transport Mode, Deactivating

WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Risk of injury due to unintended engine start on high-voltage vehicles!

Pay attention to the high-voltage system warning messages:
For procedures where the ignition must be switched off, refer to PROCEDURES THAT NEED IGNITION SWITCHED ON .

NOTE:

The Full pre-delivery inspection test program may also be performed as part of the pre-delivery inspection.

Procedure :

-- Connect the Vehicle Diagnostic Tester. Refer to VEHICLE DIAGNOSTIC TESTER, CONNECTING .

-- Select the Diagnostic mode and start the diagnosis.

-- Perform the vehicle identification.

-- Deselect "Working with Guided Fault Finding" by removing v and pressing Accept .

-- Switch to the "Special Functions" tab and select the following program:

34 - Activate/deactivate vehicle transport mode

-- Start the program using Perform test... .

-- Continue the program sequence.

NOTE:

The vehicle can lower by deactivating the vehicle transport mode.