Battery A

WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Procedure :

-- Connect the Vehicle Diagnostic Tester. Refer to VEHICLE DIAGNOSTIC TESTER, CONNECTING .

-- Select the Diagnostic mode and start the diagnosis.

-- Perform the vehicle identification.

-- Set v and press Accept to select "Work with Guided Fault Finding" .

-- Switch to the "Special Functions" tab and select the following program:

A - Battery, Checking

-- Start the program using Perform test... .

-- Continue the program sequence.

-- The following actions are derived from the test result:

-- Switch to the control modules tab.

-- Press the X Diagnosis button and end the diagnosis.

-- Send the diagnostic log online.

NOTE:

A functioning network connection is required for sending the diagnostic log online.

After the diagnosis is complete, a confirmation that the log was sent successfully will be sent.

Vehicle Diagnostic Tester result:	Action:
"Battery is OK"	No further action is necessary.
"Battery, Charging"	Charge the battery. Refer to BATTERY A, CHARGING .
"Battery no longer meets the delivery quality"	Replace the battery. Refer to BATTERY A, REMOVING AND INSTALLING, VEHICLES WITHOUT ALTERNATIVE DRIVE SYSTEM, (0K0) , or BATTERY A, REMOVING AND INSTALLING, VEHICLES WITH HIGH-VOLTAGE SYSTEM, (0K3) , or BATTERY A, DISCONNECTING AND CONNECTING, VEHICLES WITH ALTERNATIVE DRIVE SYSTEM, (0K4) .