LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2024 >> S3 Premium Plus >> Repair and Diagnosis >> External Pages >> Different car >> Section 287 (Crankshaft, Cylinder Block (4-Cylinder Direct Injection 2.0L 4V TFSI Engine (Ea 888EVO4))) >> 13 Crankshaft, Cylinder Block >> Cylinder Block, Belt Pulley Side >> Ribbed Belt TENSIONER, Removing And Installing >> Ribbed Belt TENSIONING Damper, Removing And Installing, Vehicle With Starter Generator >> Notes

Ribbed Belt TENSIONING Damper, Removing And Installing, Vehicle With Starter Generator: Notes

WARNING: This page is about a different car, the 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Removing

After each repair there are two possibilities for the removal of the ribbed belt tensioner:

1. If the ribbed belt is installed:

TIP:

If the ribbed belt tensioner should be replaced, a commercially available steel pin (4 mm diameter) can be used for securing the tensioner instead of the Locking Pin:T10060A  .

-- Remove the ribbed belt from the tensioner. Refer to RIBBED BELT, REMOVING AND INSTALLING .

scientia non olet · About LEMON Manuals