Bumper Carrier, Removing And Installing, Equipment Version Without Trailer Hitch: Installing
WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
- The bumper carrier must be at room temperature.
- The adhesive surface must be free of dirt and grease.
-- Remove the adhesive residue from the body.
-- Clean the adhesive surface using the Cleaning Solution :D 009 401 04 .
-- Remove the protective film from the adhesive tape and tape the foam seal on the bumper carrier according to the dimensions.
- Dimension -a- = 49.6 ± 2 mm
- Dimension -b- = 12.9 ± 2 mm
- Dimension -c- = 2.1 ± 2 mm
- Dimension -d- = 0 ± 2 mm
- Bumper carrier resting time is at least 30 minutes at room temperature.