Bumper Cover, Removing And Installing, A6, A7 SPORTBACK: Removing

-- Remove the bolts -arrows-.

Courtesy of AUDI OF AMERICA, LLC

• A6: Quantity: 7
• A7 Sportback: Quantity: 5

-- Push in the front wheels and loosen the wheel housing liner near the front bumper cover. Refer to OVERVIEW - FRONT WHEEL HOUSING LINER .

-- Remove the bolt -2-.

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connectors -1-.

Right Side of Vehicle:

Courtesy of AUDI OF AMERICA, LLC

-- Place a drip tray under the hose coupling for the washer fluid hose.

-- Slide the clip -2- out and disconnect the washer fluid hose for the laser distance regulation control module -1-.

-- Seal the hose couplings with clean plugs from the Engine Bung Set :VAS 6122  .

-- If equipped, disconnect the connector -arrow-.

Courtesy of AUDI OF AMERICA, LLC

Continuation:

-- Remove the lock carrier cover. Refer to LOCK CARRIER COVER, REMOVING AND INSTALLING, A6, A7 SPORTBACK .

-- Slide out the clamp -2- and disconnect the washer fluid hose -1- for the night vision system camera.

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connectors -1, 2 and 4- and free up the wiring harness.

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -3- by removing the connector lock and pressing it down.

-- Remove the bolts -arrows-.

Courtesy of AUDI OF AMERICA, LLC

-- Disengage the side piece from the front side panel in direction of -arrow A- and remove the bumper cover -1- with the help of a second technician in direction of -B arrows-. 

Courtesy of AUDI OF AMERICA, LLC