Auxiliary Heater Heating Element -Z35-, REMOVING AND INSTALLING: Removing
Vehicles with High-Voltage System
-- Switch off (deactivate) the "parking air conditioner". Refer to Owner's Manual.
Continuation for All Vehicles
-- Move the right front seat all the way to the rear.
-- Switch the ignition off.
-- Remove the footwell vent on the front passenger side. Refer to FRONT PASSENGER SIDE FOOTWELL VENT, REMOVING AND INSTALLING .
-- If equipped, remove the air duct for the glove compartment cooling. Refer to AIR GUIDE FOR GLOVE COMPARTMENT COOLING, REMOVING AND INSTALLING .
-- Remove the screw clips -A-.
-- Loosen the insulation -B- from the heater and A/C unit air intake housing and remove.
Vehicles with PR number 9AQ
-- Remove the bracket for the right adjustment motors. Refer to BRACKET FOR RIGHT ACTUATORS, REMOVING AND INSTALLING, PR NUMBER 9AQ .
Risk of short circuit when disconnecting the voltage supply to the.
- Interrupt the power supply to the Auxiliary Heater Heating Element -Z35- by pulling on the related fuse. Refer to Wiring Diagram.
- Before loosening the bolts with a voltage tester that there is no more voltage.
-- Interrupt the power supply to the Auxiliary Heater Heating Element -Z35- by pulling on the related fuse. Refer to Wiring Diagram.
-- Disconnect the connector -B- for the Auxiliary Heater Heating Element -Z35- -A-.
-- Remove the bolts -A-.
There is a risk of burns by the metal surfaces on the auxiliary heater heating element. Heating elements can be very hot.
It is possible for the skin to be burned.
- Wear safety gloves.
- Never touch the metal surfaces of the heating element.
-- Pull the Auxiliary Heater Heating Element -Z35- -B- from the installation slot of the heater and A/C unit.