Belt Pulley, Removing
WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Mount the arms on the puller so that the outside of the belt pulley does not get bent if the belt pulley -A- is going to be used again.
- If the belt pulley -A- (after removing the circlip) cannot be removed from the A/C compressor flange by hand (for example because of debris), carefully remove the belt pulley as described below.
-- Remove the belt pulley -A- with a puller (three arm) -B- while noting the following.
- Do not support the puller spindle -B- on the A/C compressor shaft when removing the belt pulley -A-.
- Use a sleeve -C- (for example, Sleeve VAG1719/1 taken from A/C Clutch Set :VAG1719 ) to support the spindle on the arm puller -B- on the A/C compressor flange.
-- Clean the flange on the A/C compressor thoroughly after removing the belt pulley -A-. It must possible to install the belt pulley -A- by hand.