Starter, Removing And Installing, 2.5L TFSI, Dual Clutch Transmission: Removing
WARNING: This page is about a different car, the 2022 Audi S3, 2022 Audi RS 3, 2022 Audi A3 Quattro, and 2022 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
-- Disconnect the ground cable from the battery when the ignition is switched off. Refer to Battery -A-, DISCONNECTING AND CONNECTING, IN LUGGAGE COMPARTMENT (0K0) .
-- Remove the air filter housing. Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING .
-- Free up the transmission ventilation hose -1- and pivot to the side in the direction of -arrow-.
-- Disconnect the connector -6- by sliding the retainer back and pressing the release down.
-- Remove the cap -7-.
-- Remove the nut -8- and remove the terminal 30/B+ wire.
-- Remove the bolt -4-.
-- Remove the nut -2- and free up the ground wire -1-.
-- Remove the double bolt -3-.
-- Remove the starter -5- upward between the coolant hoses.