Parking Brake, Manually Loosening

WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Due to a mechanical or electrical malfunction, it may be required to mechanically release the parking brake in order to move the vehicle.

Procedure

CAUTION:

Risk of accident due to the vehicle rolling away.

- Before removing the parking brake motor, secure the vehicle from rolling.

-- Release the parking brake.

-- Switch off the ignition.

-- Remove the rear wheel. Refer to WHEELS AND TIRES .

-- Disconnect the connector -3- for the parking brake motor.

Courtesy of AUDI OF AMERICA, LLC

-- Open the clip -2- and free up the brake pad wear indicator wire.

-- Remove the bolts -arrows-.

-- Remove the parking brake motor -1- from the brake caliper.

-- Remove the seal.

-- Using a TX45 socket -arrow-, turn the drive axle back until the brake is loosened.

Courtesy of AUDI OF AMERICA, LLC

-- After eliminating the fault, install the parking brake motor. Refer to LEFT AND RIGHT PARKING BRAKE MOTOR -V282- / -V283-, REMOVING AND INSTALLING .

Tightening Specifications

Refer to OVERVIEW - PARKING BRAKE
Refer to WHEELS AND TIRES .