Brake Caliper, Removing And Installing, Six-Piston Ceramic Brake: Installing

WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal while noting the following:

CAUTION:

Health risk due to toxic dust from the brake system.

Irreversible deposit of dust particles in the lungs. Breathing impairments may occur.

- Never blow out the brake system with compressed air.

Use only mineral spirits to clean the brake caliper.
Check the protective caps of the brake caliper pistons for damage and install the complete repair kit, if necessary. Refer to BRAKE CALIPER PISTON, REMOVING AND INSTALLING, SIX AND TEN-PISTON BRAKE .

-- Slide the brake caliper with the brake pads installed carefully over the brake rotor.

-- Secure the brake hose -3- to the bracket.

Fig 1: Identifying Connector And Tab

Courtesy of AUDI OF AMERICA, LLC

-- Bring the connector -2- into its installed position and turn in direction of -arrow- until the tab -4- engages in the opening -5- on the bracket.

-- Connect the connector -1-.

Make sure that the connector and brake hose are routed correctly.
Make sure the brake hose is not blocked, bent, twisted or rubbing against the vehicle.

-- Install the front wheel, while observing the safety precautions for vehicles with ceramic brakes. Refer to WHEELS AND TIRES .

CAUTION:

Faulty brakes increase the risk of an accident.

- Make sure the brakes are working correctly before driving the vehicle for the first time.

-- With the vehicle stationary, firmly press the brake pedal several times so that the brake pads in the operating condition properly sit in their respective position.