Overview - Transmission Housing

WARNING: This page is about a different car, the 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Exploded View Of Transmission Cover

Courtesy of AUDI OF AMERICA, LLC

Circlip
Pinion Roller Sleeve
- Bearing "I"
- Removing. Refer to Figure.
- Installing. Refer to Figure.
Transmission Housing
Seal
- For the transmission output shaft.
- Only on vehicles with an all-wheel drive clutch
- Replacing. Refer to TRANSMISSION OUTPUT SHAFT SEAL, REPLACING .
Cap
- Replace after removing
- Removing. Refer to Figure.
- Installing. Refer to Figure.
Fluid Catch Tray
- Replace after removing
Input Shaft Ball Bearing
- Bearing "E"
- Installation position: the surrounding groove points to the transmission housing.
- Removing. Refer to Figure.
- Installing. Refer to Figure.
Circlip
- Installation position. Refer to Figure
Roller Sleeve for the Output Shaft
- Bearing "F"
  FWD Vehicles
- Replace after removing
- Removing. Refer to Figure.
- Installing. Refer to Figure.
  AWD Vehicles
- Removing. Refer to Figure.
- Installing. Refer to Figure.
Circlip
- Different versions
- Refer to the Parts Information for the allocation.