Input Shaft Seal, Replacing, Clutch Cover: Installing
WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Place the Assembly Sleeve:T40308 on the drive axle.
-- Drive in the new seal with the Thrust Piece:T50038 in the clutch housing until it stops.
-- Remove the Assembly Sleeve:T40308 .
-- Install the flywheel. Refer to FLYWHEEL, REMOVING AND INSTALLING .