Raising And Lowering With Open And Closed Air Suspension System

WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Raising with air suspension system not open

-- If the clearance for the hoist arms is insufficient, the set the vehicle to "lift" (highest level) before lifting the vehicle on the shop hoist and turn on the "vehicle lift mode". Refer to the Owner's Manual.

This ensures that the hoist arms can pivot under the vehicle and the air suspension system will not make any unintended adjustments.

-- Position hoist lifting arms under intended lift points on longitudinal members and raise vehicle.

Lowering with air suspension system not closed

-- Lower hoist and place vehicle on wheels.

-- Swing back the hoist lifting arms.

-- Switch off the "vehicle lift mode" and select a driving mode. Refer to the Owner's Manual.

TIP:

"Vehicle lift mode" is automatically deactivated when vehicle speed exceeds 10 km/h (6.2 mph).

Lifting with the air suspension system opened

If the vehicle was lifted with the air suspension system open, then read the points in the sequence specified in "lowering with the air suspension system opened" before lowering the vehicle back onto it wheels.

Lowering with open air suspension system

-- Connect all air lines to their corresponding components.

-- Fill the system. Refer to AIR SUSPENSION SYSTEM, FILLING AND BLEEDING .

-- Lower the vehicle onto its wheels.

-- Switch off the "Vehicle lift mode". Refer to the Owner's Manual.

TIP:

"Vehicle lift mode" is automatically deactivated when vehicle speed exceeds 10 km/h (6.2 mph).