Pressure Reservoir, Draining
WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Procedure
- Follow the guidelines for clean working conditions. Refer to GUIDELINES FOR CLEAN WORKING CONDITIONS .
-- Remove the affected rear wheel. Refer to WHEELS AND TIRES .
-- Remove the corresponding rear wheel housing liner. Refer to OVERVIEW - REAR WHEEL HOUSING LINER .
-- Vent the system. Refer to AIR SUSPENSION SYSTEM, FILLING AND BLEEDING .
-- Switch off the ignition.
-- Slowly loosen the air line -arrow- to the affected pressure reservoir and allow air pressure to come down. After the air pressure has escaped, remove the air line. (Shown on the left pressure reservoir.)
-- Remove and dispose of the pressure reservoir. Refer to PRESSURE RESERVOIR, REMOVING AND INSTALLING .
- If the air line is removed from a component, check if the cutting ring is seated on the air line.