Drivetrain Control Module -J775-, REMOVING AND INSTALLING: Removing
WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- If the Drivetrain Control Module -J775- is replaced, select the "Control module, replacing" program. Refer to DIAGNOSTIC ENTRIES .
-- Start the selected program and follow the instructions on the Vehicle Diagnostic Tester display.
-- Remove the center console. Refer to CENTER CONSOLE, REMOVING AND INSTALLING .
-- Equipped on some models: remove the rear air duct. Refer to appropriate Service Information .
-- Remove the nuts -Arrows B- and -Arrows C-.
-- Free up the wiring harness -arrow A- and remove the cover -1-.
-- Remove the nuts -arrows- and remove the Drivetrain Control Module - J775- -1-.
-- Disconnect the connector -2-.