Standard Vehicle Height, Readapting
WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Vehicle Diagnostic Tester
Procedure
The standard vehicle height must be readapted, if:
- The coupling rod on a level control system sensor was loosened from the control arm.
- A level control system sensor was removed or installed / replaced.
- A shock absorber with the damping adjustment valve was replaced on the front or rear axle.
- An air spring strut on the front or rear axle was replaced.
- The Drivetrain Control Module -J775- was loosened and reattached / removed and installed / replaced.
- The vehicle must be standing on a level surface.
- The vehicle may not be loaded.
-- If the standard vehicle height is configured, then select the "Basic Setting, Complete" program. Refer to DIAGNOSTIC ENTRIES .
-- Start the selected program and follow the instructions on the Vehicle Diagnostic Tester display.