Component Location Overview - Electrical Components
WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Drivetrain Control Module -J775-
- Installation location: on the center tunnel
- Removing and Installing. Refer to Drivetrain Control Module -J775-, REMOVING AND INSTALLING .
- Front Level Control System Sensor
- Left Front Level Control System Sensor -G78-
- Right Front Level Control Sensor -G289-
- Overview. Refer to OVERVIEW - FRONT LEVEL CONTROL SYSTEM SENSOR .
- Rear Level Control System Sensor
- Left Rear Level Control System Sensor -G76-
- Right Rear Level Control System Sensor -G77-
- Overview. Refer to OVERVIEW - REAR LEVEL CONTROL SYSTEM SENSOR .
- Level Control System Compressor Electronics -J1135-
- Removing and Installing. Refer to Level Control System Compressor Electronics -J1135-, REMOVING AND INSTALLING .
- Level Control System Compressor Motor -V66-
- With integrated Level Control System Solenoid -N111-
- The Level Control System Solenoid - N111- cannot be replaced separately, if faulty replace the Level Control System Compressor Motor -V66-
- Overview. Refer to OVERVIEW - AIR SUPPLY UNIT .
- Adaptive Suspension Valve Block -NX7-
- With the following integrated components:
- Level Control Pressure Sensor -G291-
- Left Front Suspension Strut Valve -N148-
- Right Front Suspension Strut Valve -N149-
- Left Rear Suspension Strut Valve -N150-
- Right Rear Suspension Strut Valve -N151-
- Level Control Accumulator Valve -N311-
- The components cannot be replaced separately.
- If a components is faulty replace the adaptive suspension valve block
- Overview. Refer to OVERVIEW - AIR LINES .
- If the air line is removed from a component, check if the cutting ring is seated on the air line.
- Secure fit of the air line cannot be guaranteed without the cutting ring.
- With the following integrated components: