Left Rear Parallel Parking Assistance Sensor -G716- /Right Rear Parallel Parking Assistance Sensor -G717-, REMOVING AND INSTALLING: Removing
WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- A6, A7 Sportback: remove the rear bumper cover side piece. Refer to BUMPER COVER, REMOVING AND INSTALLING .
-- RS 6 Avant, RS 7 Sportback: detach the rear wheel housing liner at the area of the bumper cover and push to the side.
-- Press both retainers to the side in the direction of -arrows- and at the same time, push the sensor -1- through from the outside toward the inside.
-- Disconnect the connector -2- by sliding the retainer -3- toward the rear and pressing the release down.