Lane Change Assistance, Calibrating, Dynamic Calibration

WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Calibration/adjustment must be performed if:

"No or incorrect basic setting/adaptation" is actively entered in the DTC memory of the Lane Change Assistance Control Module -J769- / Lane Change Assistance Control Module 2 -J770-.
The Lane Change Assistance Control Module -J769- and/or Lane Change Assistance Control Module 2 -J770- has/have been removed and installed or replaced.
The rear bumper was removed and installed.
The rear bumper cover has been damaged or replaced.
The rear bumper cover was painted near the control modules while installed.

TIP:

When a software update should be made, this must be performed before the calibration.

Special tools and workshop equipment required

Vehicle Diagnostic Tester

Procedure

-- Connect the Vehicle Diagnostic Tester. Refer to => Vehicle Diagnostic Tester .

-- Switch the ignition on.

-- Select the Test plan tab.

-- Select the individual tests button.

Dynamic Calibration for Lane Change Assistance Control Module

-- Select the following items in the tree structure one after the other.

Diagnostic-capable systems
00CF - Lane Change Assistance Control Module 2 -J770-
00CF - Lane Change Assistance Control Module 2, Functions
00CF - Calibration

-- Start the selected program and follow the instructions on the display of the Vehicle Diagnostic Tester by running a short calibration run.

Dynamic calibration of several driver assistance systems.

When driving the vehicle for calibration, the lane change assistance control modules can also be calibrated together with the front corner radar control modules; to do so, select the following items in the tree structure:

Diagnostic-capable systems
00CF - Lane Change Assistance Control Module 2 -J770-
00CF - Lane Change Assistance Control Module 2, Functions
00CF - Dynamic Calibration of all Driver Assistance Systems

-- Start the selected program and follow the instructions on the display of the Vehicle Diagnostic Tester by running a short calibration run.

After Successful Calibration

-- Switch the ignition off.

-- Disconnect the Vehicle Diagnostic Tester from the diagnostic connection.