Antenna Amplifier -R24- /Antenna Amplifier 2 -R111- /TV Antenna Amplifier 3 -R84-, REMOVING AND INSTALLING, A6 AVANT: Removing
WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Turn off the ignition and all electrical equipment. Set the ignition key outside of the vehicle.
-- Remove the rear lid upper trim panel for the Antenna Amplifier -R24- /Antenna Amplifier 2 -R111-. Refer to the appropriate service information .
-- Remove the rear lid lower trim panel for the TV Antenna Amplifier 3 -R84-. Refer to the appropriate service information .
-- Release and disconnect the connectors -1- and -4- from the antenna amplifier -2-.
-- Loosen the screw -3- several turns and remove the antenna amplifier -2- from the rear lid.