Potential Equalization Measurement
WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
After installing the high-voltage components or potential equalization cables a potential equalization measurement must be performed on the applicable high-voltage components.
- The 12 V and the high-voltage connections are not yet connected to the high-voltage component
- The potential equalization cable is installed correctly and is connected to the high-voltage component
-- Connect the Vehicle Diagnostic Tester.
-- Select the ODIS service mode and start.
-- Select the special functions tab.
-- Select one after the other:
- High Voltage
- Potential equalization measurement on high-voltage components
-- Start the selected program and follow the instructions on the Vehicle Diagnostic Tester display.