Driver Seat Heating Element -Z6- /Front Passenger Seat Heating Element -Z8-, REMOVING AND INSTALLING
WARNING: This page is about a different car, the 2022 Audi S3, 2022 Audi RS 3, 2022 Audi A3 Quattro, and 2022 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
- Excluding North America market-specific versions with passenger occupant detection system (front passenger seat): the old heating elements remain on the cushion and will be covered over by the new heating elements.
- North America market-specific versions with passenger occupant detection system (front passenger seat): it is not permitted to interchange the components. The heating element with passenger occupant detection system along with the seat cushion are always to be replaced.
Procedure
- Cover and cushion separated. Refer to COVER AND CUSHION, SEPARATING FROM SEAT PAN .
-- Clip the wires directly at the heating elements.
-- Align the new heating elements -arrow- on the cushion (example image).
-- Remove the protective films from the heating elements in succession, taking care not to damage the heating elements.
-- Glue the heating elements so that they align with the old heating elements and are free of wrinkles.
-- Route the connecting wires to the individual heating elements in the base of the gaps.
Further installation is performed in reverse order of the removal.