Vacuum Pump, Removing And Installing, 2.0L TDI EVO Engine: Installing
WARNING: This page is about a different car, the 2024 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
- Replace the seal after removal.
- Check the vacuum lines for damage before assembling and replace if necessary.
-- Position the vacuum pump driver -1- so it engages in the symmetrical groove on the camshaft when positioning -arrows-.
-- Install the air duct pipe. Refer to OVERVIEW - CHARGE AIR SYSTEM .
-- Install the plenum chamber bulkhead. Refer to PLENUM CHAMBER BULKHEAD, REMOVING AND INSTALLING .
-- Install the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .