Brake Booster Pressure Sensor, Removing And Installing: Removing
WARNING: This page is about a different car, the 2024 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.
LHD vehicles:
-- Remove the plenum chamber cover. Refer to PLENUM CHAMBER COVER, REMOVING AND INSTALLING .
RHD vehicle:
-- Remove the seal and lift the plenum chamber cover.
Continuation for All Vehicles:
-- Disconnect the connector -1-.
-- Release the retainers -arrows- and carefully remove the Vacuum Sensor -G608- -item 2-.