Cover And Cushion, Removing And Installing, Bench Seat: Installing
WARNING: This page is about a different car, the 2024 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.
 Courtesy of AUDI OF AMERICA, LLC
|
Install in the reverse order of removal while noting the following:
-- Engage the rear molding into the seat frame first, and then pull the cover tight.
-- Flip the protective strip -1- over 180° toward the inside -arrow A-.
-- Engage the protective strip in the groove on the molded part -arrow B-.