Backrest Heating Element, Removing And Installing

WARNING: This page is about a different car, the 2024 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

The old seat heating element remains on the cushion and will be covered by the new heating element.

Procedure

Cover and cushion separated. Refer to BACKREST COVER AND CUSHION, SEPARATING .

-- Cut the wire directly on the old heating element.

Standard/Bucket Seat:

Courtesy of AUDI OF AMERICA, LLC

-- Align the new heating element -arrow- on the cushion (example image).

-- Peel the protective film off the heating element one after the other. Be careful not to damage the heating element.

-- Glue the heating element so that it aligns with the old heating element and is not wrinkled.

-- Route the connecting wires to the individual heating elements in the base of the gaps.

Sport Seat:

Courtesy of AUDI OF AMERICA, LLC

-- Align the new heating element -arrow- on the cushion.

-- Peel the protective film off the heating element one after the other. Be careful not to damage the heating element.

-- Glue the heating element so that it aligns with the old heating element and is not wrinkled.

-- Route the connecting wires to the individual heating elements in the base of the gaps.

Super Sport Seat:

Courtesy of AUDI OF AMERICA, LLC

-- Align the new heating element -arrow- on the cushion.

-- Peel the protective film off the heating element one after the other. Be careful not to damage the heating element.

-- Glue the heating element so that it aligns with the old heating element and is not wrinkled.

-- Route the connecting wires to the individual heating elements in the base of the gaps.

Further installation is performed in reverse order of the removal.